Portal Home > Knowledgebase > Articles Database > Removing stale paths under Veritas
Removing stale paths under Veritas
| Posted by YUPAPA, 05-12-2014, 11:07 AM |
| Does anyone know how to remove stale paths under Veritas on Linux?
I used the following for solaris, not sure whats equivalent for linux. What caused the stale paths was basically I masked additional pair of new fc-paths and took out the olds. Thanks.
|
| Posted by tbenoit, 05-12-2014, 06:16 PM |
| Have you tried running "vxdctl enable"?
If that didn't work, and you still see the paths that are gone in VxVM (and you are particular they are actually gone), you may need to kill the vxconfigd daemon, restart it and potentially run "vxdctl enable" again. The restart of that daemon should not cause an outage (I have never had it do so).
|
| Posted by YUPAPA, 05-15-2014, 12:18 AM |
| Thanks. vxdctl alone did not remove the paths. Had to do the following in case anyone would know.
|
Add to Favourites 
Print this Article
Also Read
c (Views: 526)
